English -1002 anonymous DIY: How to Fertilize | Garden Club | Home Depot Canada
Home>Garden Club>Articles>DIY: How to Fertilize
Plant Tag Library

Plant Tag Library

Browse our library or use your Plant Tag code for details about your plants.

Search Now
Do-It-Yourself Projects

Do-It-Yourself Projects

Find exciting and practical ideas for gardening projects.

Get Started


Watch our videos for great gardening tips and advice.

Watch Now

DIY: How to Fertilize

Discover how easy it is to feed your turf with fertilizer.

Broadcast spreader with fertilizer
For best results, start with an easy and inexpensive soil test, which tells you how much fertilizer to apply and what formulation to use. (A good choice is a fertilizer that has 50 percent or more of the nitrogen in a slow-release form from brands such as Scotts or Vigoro. These formulas are less likely to leach into groundwater.)

Follow the directions on the fertilizer bag; most fertilizers are formulated to supply about 1/2 to one pound of nitrogen per feeding.

5 steps:
1. Measure Out Fertilizer
2. Fill the Spreader
3. Apply the Fertilizer
4. Spread Evenly
5. Water

Measure out fertilizer

Step 1: Measure out fertilizer

Follow the directions on the bag carefully. Determine the size of your yard then measure out the right amount of fertilizer. Depending on the measurement, using the whole bag may mean you're applying too much or too little. Never apply more fertilizer than the soil test or fertilizer label instructs.
Fill the spreader

Step 2: Fill the spreader

Fill the spreader while standing on pavement so you can clean up any spills. Sweep any fertilizer that lands on your walk, driveway or patio back onto the grass. Remember: 100 percent of any fertilizer that remains on a hard surface will end up in the storm drain or in streams and rivers.
Apply the fertilizer

Step 3: Apply the fertilizer

Begin fertilizing with your spreader at one end of your yard. This will provide a convenient starting and stopping point for each pass. Pay attention to how much you're overlapping each pass to avoid double-dosing the grass.

If your lawn is oddly shaped, make header strips (an already mowed piece of grass where a lawn mower can be easily turned around) around its entire perimeter.  Leave a 20-foot safety zone around wells and streams where no fertilizer is applied.
Spread evenly

Step 4: Spread evenly

Once the header strips are down, walk back and forth between them, spreading the fertilizer. Begin walking before you open the chute and close it just before you reach the far header to avoid leaving piles of fertilizer at your starting and stopping points. Shut off the spreader if you must travel over pavement.

Walk at a steady pace. Your speed affects the rate at which the fertilizer is applied. A moderate speed is best. Watch for dips in the ground, which can cause fertilizer to spill out. Walk in a straight line so the wheel tracks from the first pass will give you a guideline to follow on the next one.
Water as needed

Step 5: Water when needed

Unless you're using a combination fertilizer, water after you fertilize so it moves down to the roots. To see if watering is needed (and how often), check the label instructions.

Related Content

garden club ${pageType}