Build an Open Shelving Unit
A well-designed bookcase has lots of uses besides book storage. You can use it to display special three-dimensional pieces, collections and even framed artwork. With their open backs, two or three units together can also be used as a room divider. You can make one unit or more this is an easy-to-build project.
9 StepsShow all steps »
Create a box
From the 16" x 8' pieces, cross cut 2 pieces at 58-3/4" for the sides and 2 pieces at 32" for the top and bottom. These will form the outer box for your bookcase, measuring 32" x 60". Predrill and countersink screw holes. Apply glue to a 5/8" strip at outer edges of the 32" pieces and butt joint them onto the top and bottom edges of the longer pieces.
Cutting shelves and dividers
From the remaining 16" x 8' pieces, cross cut 3 pieces at 30-3/4" and 12 at 13-7/8".
Drill and countersink 4 holes in the 2 30-3/4" boards. Add glue to one side of each board a roller makes the job easy. Clamp one board to the inside of the box top and one to the inside of the bottom. Screw them in place.
Adding shelf supports
On 2 of the 13-7/8" boards, drill and countersink 4 holes. Glue one side of each and clamp to the bottom sides, butted directly on top of the boards you added in Step 4. Screw in place. These support your first shelf.
Adding the first shelf
Using a 30-3/4" board, add glue to a 5/8" wide strip at each end of one side. Place this board, glue side down, on top of the 2 side supports. Drill, countersink and screw boards in place from the outside of the box, forming your first shelf. Repeat Steps 5 and 6 to create your remaining 2 shelves.
Making vertical dividers
First cut 2 spacer blocks measuring 9-1/2" x 16", to help you position the verticals. Starting at the bottom left of your box, place one spacer atop the bottom of the box and one under the first shelf. Now glue the ends of a 13-7/8" board and fit it against the end of the spacers. Drill, countersink and screw the board in place through the horizontal surfaces. Lay your box on its side and repeat Step 7. Add the remaining verticals, alternating sides for the second and fourth display spaces.
Fill all screw holes and visual gaps with wood filler. Sand all surfaces with fine grade sandpaper.
Your quick rate has been submitted.
Please note it may take up to 8 hours for your quick rating to appear.
Sorry we are currently experiencing technical difficulties. Please try and resubmit your Quick Rating.
Skill Level: Intermediate
Time: 8 hours
Due to differing conditions, tools, and individual skills, The Home Depot® assumes no responsibility for any damages, injuries suffered, or losses incurred as a result of attempting to replicate any of the home improvement ideas portrayed in this website Before beginning any home improvement project, review it thoroughly to ensure you or your contractor can finish the project and if any doubts or questions remain, consult local experts or authorities. Because codes and regulations vary greatly, you always should check with authorities to ensure that your project complies with all applicable local codes and regulations. Always read and observe all of the safety precautions provided by any tool or equipment manufacturer, and follow all accepted safety procedures.
Build a Bespoke BookcaseGet Started »
Build a BookcaseGet Started »
Build a Dressing Mirror with StorageGet Started »
Build a Kids Storage BoxGet Started »
Build Bookcases with a Window SeatGet Started »
Building a Closet OrganizerGet Started »
Constructing a Built-In Shelving UnitGet Started »
Install a Kitchen ShelfGet Started »
Install an Over-the-door Décor ShelfGet Started »
Installing a Closet-Organizer SystemGet Started »
Lattice Room DividerGet Started »
Make a Wall NicheGet Started »