Projects

Clearing a Fixture Drain Line

Project Overview

If your sink is backed up but the clog isn't in the trap, it's probably further in the drain system – in the drain lines inside your walls. To reach this kind of clog, you'll need a snake – a tool designed just for this type of job. An inexpensive hand snake, sometimes called an auger, comes with about 25 feet of flexible steel cable that threads easily into drain lines. The tip of the cable is designed to bore through clogs or grab onto obstructions so you can pull them out. With a little practice you'll be able to snake out a clogged drain in no time.

Step 1

Remove the trap and set it in a bucket

Remove the trap and set it in a bucket. By hand, thread the end of the snake into the drain line opening until it meets some resistance. This usually means that the end of the snake has reached a bend in the drain pipe.

Step 2

Set the Cable

To get past the bend, leave at least 6 inches of cable extending from the opening and tighten the cable lock. Crank the snake handle clockwise to move the end of the cable past the bend, pushing gently on the cable as you do.

Step 3

Locate the Clog

Release the lock and continue pushing the cable into the opening until you feel firm resistance. Set the snake lock and crank the handle clockwise. Solid resistance that prevents the cable from advancing indicates there's a clog. Some clogs, such as a sponge or an accumulation of hair, can be snagged and pulled out (step 4). If you can advance the cable slowly, you're probably boring through a soap clog (step 5).

Step 4

Remove Obstruction

You can pull an obstruction out of the line by releasing the snake lock and cranking the handle clockwise to wind up the cable. If the cable releases suddenly, it may have lost its grip on the object and you'll have to try to snag it again.

Step 5

Bore Through the Soap Clog

Bore through the soap clog by cranking the snake handle clockwise while applying steady pressure on the hand grip. Repeat the procedure several times, then retrieve the cable. Rinse the trap out in hot water (remember the drain line is disconnected!) Inspect the slip nut washer for wear and replace, if necessary. Reinstall the trap and tighten the slip nuts. Reconnect the trap and flush the system with hot water to remove debris.

Write a Review

QUICK RATE:

You have rated

out of 5 stars.

Do you want to submit this quick rating?

Yes No

Thank you!
Your quick rate has been submitted.

Please note it may take up to 8 hours for your quick rating to appear.

Sorry we are currently experiencing technical difficulties. Please try and resubmit your Quick Rating.

Thank you, you have already quick rated this product. out of 5

Project Details

Skill Level: Beginner

Time: 2 hours

Before you start, read this »

Due to differing conditions, tools, and individual skills, The Home Depot® assumes no responsibility for any damages, injuries suffered, or losses incurred as a result of attempting to replicate any of the home improvement ideas portrayed in this website Before beginning any home improvement project, review it thoroughly to ensure you or your contractor can finish the project and if any doubts or questions remain, consult local experts or authorities. Because codes and regulations vary greatly, you always should check with authorities to ensure that your project complies with all applicable local codes and regulations. Always read and observe all of the safety precautions provided by any tool or equipment manufacturer, and follow all accepted safety procedures.

Tools