Pipes and Fittings

SharkBite Max 1/2 inch Brass Push-to-Connect End Stop

SharkBite Max push-to-connect fittings are the fastest way to connect PEX, copper, CPVC, or PE-RT pipe. A newly designed stainless steel collet retainer delivers additional strength and durability and provides a 400 psi pressure rating. SharkBite Max fittings don't require a PEX tube liner, and a re-engineered body allows you to insert the pipe using less force and greater ease. No soldering, clamps, unions, glue, or special tools required. After inserting the pipe, stainless steel teeth bite down and grip the pipe tightly while a specially formulated O-ring compresses around the pipe to create a watertight seal. The fitting can be rotated after installation for quick adjustments, and removing the fitting is just as fast with a disconnect tool, allowing fittings and valves to be changed or reused.

IPEX System 15 1 1/2 inch 45 degree PVC DWV Short Elbow - HxSp

System 15 is designed for the majority of low-rise and light commercial applications where DWV systems don't run through air plenums. Connects fast and easily using solvent cement. System 15 won't rust, pit, scale or degrade, even under continued exposure to moisture, salts, aggressive soils and most acids. Grey colour PVC and System 15 labels on all fittings provides easy identification of the DWV system.

BrassCraft Gas Fitting 5/8-inch O.D. Male Flare x 1/2-inch FIP

BrassCraft's steel female gas fitting adapts a gas connector nut to appliance gas inlet, gas ball valve outlet, or to the gas supply pipe. These fittings are manufactured from solid bar stock for a seamless, durable design. The flared end of the fitting connects to the gas connector nut. The male end connects to the gas appliance inlet, gas ball valve or gas supply stub out. Fitting is used with 5/8 in. O.D. (15/16-16 thread) gas connectors for appliances with larger BTU demands such as a 5 or 6 burner stove, furnace or boiler.

Waterline 1/2 Inch Pex X 1/2 Inch Female Pipe Thread Drop Elbow

1/2" pex x 1/2" female pipe thread drop elbow is intended for potable water distribution systems. it is made from forged brass, making it approximately 15% stronger than brass counterparts and are virtually free of imperfections. this drop elbow is high quality as it is certified by the Canadian standard for pex pipe and fittings, as it has passed pressure testing at three temperatures. it has a maximum working pressure of 690kpa at 82c.