Showing 7 of 7 products
Engineered profile prevents rainwater from 'wicking' back under roofing. 10 Ft. length, slips under shingles, screw slots provided. Extends the roof-line for a continuous drip edge above gutter. No sealants or caulking required! Easy installation! Durable vinyl. Engineered to withstand North America's worst conditions (-40? to 150?F or 65?C) including ice and desert heat. Maintenance-free and never needs paint. Cleans with a hose. Guaranteed for life!
Protect your home from water damage with Peak aluminum gutter, soffit and fascia products. Featuring precision design, our products can help prevent water and moisture damage to the roof, windows, walls and foundation. Made from heavy-gauge aluminum, our products are attractive, reliable and maintenance-free. They won't rust or leak, which is ideal for keeping the exterior of your home looking pristine for many years. Our products are strong and attractive, but what makes them so unique? Every component is finished with exterior polyester paint on the outside and inside to give you a product that is durable and looks great from any angle. Plus, our gutter hanger is engineered to enable quick, safe, one-handed installation! For extra protection, add the Peak Aluminum Gutter Guard to your system to keep leaves and anything as thin as pine needles out! Use the Aluminum Fascia Cover to seal off soffit panels and add visual interest, giving a finished look to your home exterior.
Roof Guard is a pre-assmbled, easy to install automatic control that connects to a roof and gutter cable. It automatically turns on the heating cable to prevent build up of snow and ice, which can result in expensive roof repair. The sensor detects temperature and moisture and when plugged in, it automatically switches the heating cable on or off as needed. Operating costs are minimal and it helps save energy dollars. It is housed in a weather-resistant enclosure with a electronic sensor. It has a capacity of 1200 watts, 10 Amps at 120 VAC.
Prime the substrate with EXTERIOR PRIMER or H2O PRIMER. The first membrane strip should have a width of 50 cm to offset the joints of the first layer with those of the HR FINISH MEMBRANE that will be placed later. Position and unroll the membrane parallel to the edge of the roof, leaving about 8 cm at the front where the gutter will be installed. If the gutter is in place, install the membrane from the roof edge. Remove the underface protective film for a length of about 30 to 40 cm (12 to 15 in), fold this protective film at a 45 degrees angle. attach the exposed part to the support. While applying pressure to the other end of the membrane, gradually pull back the protective film using a scrubbing brush, secure the support membrane to the support while continuing to remove the protective film.