Cleaning Supplies & Accessories(363 products)

Frost Jumbo Toilet Tissue Dispenser, Steel, White Finish, 10 Inch Roll

Ideal for high traffic areas prone to vandalism. Wall mounted single roll dispenser offers durability in an attractive all metal keyed lock package. Welded all steel construction offers maximum fire protection. Dispensing: Jumbo roll, roll diameter up to 10" with 2 1/4" to 3" spindle diameter. Installation: For unrestricted access, bottom of unit to floor should not exceed 44" (112). Mounting screws provided.

Frost Stainless Steel 36 Inch Towel Bar

Stainless steel towel bar for either residential or commercial settings. Screw concealed mounting system: The mounting bracket is attached to the wall with screws at the desired height. The unit is then hooked onto the bracket. When the set screw is tightened the product is firmly secured to the wall. The set screw applies pressure to an inclined surface on the bracket this provides a rattle free and integral mounting of the product. (mounting bracket and screws provided).

Frost Shower Curtain 70 Inch X 72 Inch

The curtains are mildew proof and cold crack (-15 degrees C) treated. The shower ring grommets are reinforced with aluminum and Concealed in an extra strength header. Shower curtain comes in standard cream/white colour.

Frost Curved 60 Inch Shower Rod

Provides elegant and practical use of space in a shower curtain enclosure. For installation: Hold rod up to desired position, one person at each end, to check height and location. Be sure that rod is level. With a pencil lightly trace the top and bottom of the wall plate. Set rod down. Remove retaining screws. Separate the wall plates from the rod. Leave swivel connectors on the rod. Place wall plates back on the wall at pencil marks. Mark screw holes at 12 and 6 o'clock positions. Set wall plate aside. Read anchor instructions carefully. Drill screw holes as marked. Install 4 anchors unless a hole is on a stud. Mount wall plates, Screw in to anchors. Place rod, with swivel connectors attached and set screw holes facing up into wall plates. Screw in retaining screws. Tighten. Adjust rod. Be sure that each end of rod is into the connector far enough to engage set screws and make solid contact. Tighten set screws with allen wrench.