The BURCAM 300523 submersible effluent pump is des... See More +
The BURCAM 300523 submersible effluent pump is designed for use in residential applications either in a new installation or to replace an existing upright or submersible sump pump or effluent pump. The 1HP, 115V motor includes automatic thermal and overload protection. The vertical float switch ensures automatic operation of the pump and can be used in sump basins as small as 10-inch in diameter. The pump is equipped to handle 1/2 inch solids and includes a non-corrosive Noryl clog-free vortex impeller. The motor casing is made of stainless steel and the body is made of rugged cast iron. The maximum head is 25 feet and the capacity is up to 4400 US GPH.
1-1/2 in Brass Foot Valve for Jet and Sprinkler Pu... See More +
1-1/2 in Brass Foot Valve for Jet and Sprinkler Pumps, holds prime in pump while filtering large debris from lakes, wells, ponds, etc. This foot valve is spring loaded and manufactured with long lasting, high quality brass.
The sump check valve is installed in the discharge... See More +
The sump check valve is installed in the discharge pipe in sump pump applications. The internal check valve keeps pump fluid from flowing back into the sump basin. Includes stainless steel hose clamps.
Union Long Bronze Tank TeeLONG BRASS TANK TEE WITH UNION, 11 Inch LENGTH, 1 Inch TANK AND WATER LINE CONNECTION, 1/2 Inch PRESSURE RELIEF VALVE AND DRAIN VALVE PORT, 1/4 Inch PRESSURE SWITCH AND PRESSURE GAUGE PORT.
The Home Depot Canada
Union Long Bronze Tank Tee is rated
4.5 out of
Rated 4 out of
Nice fitting at a good priceA solid and well made tank tee. The union is easy to thread together and includes a solid rubber gasket the seals well without a whole lot of pressure on the threaded portion. It is easy to adjust once the stem is mounted on the tank to ensure the 'Tee" is exactly level with the floor. The union is not a standard 1" NPT thread so it cannot be threaded directly onto other fittings (you must use the 'stem' piece to connect to the tank). The pressure tank I used had an integrated plastic nipple with a 1" male threaded end, so I had to use a 1" coupling to connect the Tee to the tank. On the majority of tanks which have a 1" elbow exiting the bottom of the tank with a 1" NPT female thread, this will not be an issue. The ports in the Tee are sized/threaded as follows (it's a little vague in the description): the ends of the 'Tee' have 1" NPT male / 3/4" NPT female threads; the side of the 'Tee' has (2) 1/2" NPT female threads and the top has (2) 1/4" NPT female threads.