Overview
Model # KMC52000 Store SKU # 1001756308
Ideal for do-it-yourself(DIY), farm/ranch, automotive, maintenance/repair, HVAC, plumbing, on-site applications and contractor work. Duty cycle: 40% @ 40 amp, 60% @ 36 amp, 100% @ 30 amp, ambient temperature 40°C; Maximum amperage output: 40 amp; Circuit breaker requirement: 50 amp 220V recommended; Generator requirement: 5000W non-inverter type generator recommended; Open circuit voltage: 450V; Optimized cutting: 3/8-inch @ 10-inch per minute for mild steel; Recommended cutting: 1/2-inch @ 7-inch per minute for mild steel; Severance cutting: 5/8-inch @ 4-inch per minute for mild steel; Compressed air: 43.5 psi (0.3 mpa) @ 3.5 cfm; Includes: SG55 plasma cutting torch with 16 ft. lead, 10 ft. ground clamp, 5 ft. power cord with CSA approved NEMA 6-50P 220V "welder" plug. requires air compressor (not included). Recommend to use KICKINGHORSE consumable kit part numbers 07Y2517009. The KICKINGHORSE P40 is an excellent choice for small businesses and hobbyist buyers!
- HALF INCH CUTTING GUARANTEED - Rated 40% duty cycle @ 40 amp, this unit can cut 1/2-inch steel @ 7 ipm and 5/8-inch steel @ 4 ipm with unprecedented precision
- GENERATOR READY - Maintain stable performance in 160 to 270V, optimized for fluctuating dirty power. Build to run off generator or weld on-site. No capacity reduction with long extension cable
- TOUCH START - Reliable arc initiation without pilot arc. Improved start reliability, stability and rapid arc restrike with no moving parts inside the torch, minimized the chance of arc strike failure
- EASY TO SETUP, EASIER TO USE - Zero learning curve benefit from highly integrated design and automatic parameters optimization. One-knob operation with simplified torch and drag cutting technology
- PERFORMANCE YOU CAN COUNT ON - The highest in-class 450V OCV allows P40 efficiently cuts though rough, painted, and rusty surfaces. Reduced warping, and a small heat-affected zone
- COST SAVING OWNERSHIP Save up to 60% on consumables compare to other major plasma cutter brands. Only 2 parts (tip and electrode) are needed to keep the machine cutting
