Model # 00823|Store SKU # 1000858215
Sealant used to seal membrane joints and self-adhesive sealing strips. It is also used to seal the roof details (valleys, vents, chimney base, etc.) and for caulking windows and doors and to repair various joints, holes and cracks. Reflective aluminum pigments are distributed throughout the product for better UV resistance throughout the product life. Installation: Apply ELASTOMERIC SEALER ALU using a standard extrusion gun.
Formerly branded Bakor, Henry Durable Roof Patch 810-21 is a solvent-type rubberized, plastic cement composed of asphalt, fibre, solvent and fillers. The asbestos-free formulation provides weather resistance, flexibility and ease of application. Henry Durable Roof Patch 810-21 is used as a weatherproofing compound for seams, joints and cracks and for repairing roofs, flashings, vents, copings, drain pipes eaves, skylights and parapet walls. It also is used for cementing down loose shingle tabs. Henry Durable Roof Patch 810-21 can be applied to wet or dry surfaces.
Formerly branded Black Knight, Henry Wet/Dry Roof Repair has a heavy bodied trowel grade formulation designed to repair wet surfaces. Seals cracks and holes in and around roofs, flashings, skylights, chimneys and vent pipes. Use with reinforcing fabric to seal moving cracks and joints. Available in 300ml and 800ml cartridges.
Formerly branded Bakor, Henry Plastic Roofing Cement is a plastic cement composed of asphalt, fibre, solvent and fillers. The trowel-grade formulation provides weather resistance, flexibility and ease of application. Bakor 810-20 is used as a weatherproofing compound for seams, joints and cracks and for repairing roofs, flashings, vents, copings, drain pipes eaves, skylights and parapet walls. It also is used for cementing down loose shingle tabs.
Adhesive membrane roofing underlayment consisting of a reinforced glass mat and sand covered surface which is slip resistant. Installation: If conditions require, prepare the substrate with EXTERIOR PRIMER or HO PRIMER. Position the membrane parallel to the roof edge while leaving about 8 cm at the front where the gutter will be installed. Fold the sheet over itself, by half of its width, or 50 cm over the whole length already positioned. It is recommended to kneel on the unfolded portion of the membrane to keep it in place during this operation. Remove the protective film from the folded section while placing the membrane on the support. The self-adhesive portion will adhere to the support. Then take the other side of the membrane and repeat the previous two steps. Immediately apply pressure on the membrane using a heavy metal roller or a hard rubber roller to ensure adhesion between the support and the membrane and avoid forming bulges, folds or gaps. Note:
