Model # PTC120-7W-040-WY|Store SKU # 1001798856
Fasten male and female pipes securely and with confidence.
AccuCrimp Engineered Test Plug is a great alternative to brass but connected using the same crimping methods as brass fittings. Use in well water sourced potable water. Being made of engineered plastic makes it resistant to chlorine stress crack corrosion and scaling. Has unique positioning tabs that provide accurate crimp positioning every time. No problems with crimping too far back or too far forward, preventing leaks.
Cap and cover pipe ends securely with this handy little plug.
PVC material is Corrosion resistant. Temperature rating 140F. PSI is based on water at 73F. Derate 50% at 110F and 78% at 140F.
A burst water pipe in the dead of winter can be a huge inconvenience and completely replacing the insulation needed to prevent pipes in perimeter walls and crawlspaces from freezing can be cost-prohibitive. To keep your most vulnerable pipes from freezing, the simple and DIY-friendly solution is to install a PRO-Tect heating cable for pipes. This 120 V plug-in heating cable generates heat (7 watts per linear foot) which will keep your pipes from freezing in low temperatures. The integrated thermostat control, located between the non-heating lead cable and the heating wire itself, will ensure a consistent temperature while minimizing energy use. The thermostat turns the heating cable on when exposed to temperatures below 37.4°F (3°C). It will shut the heating cable off when the pipe has been heated to a temperature of approximately 50°F (10°C). The cable is covered by a 2-year warranty.
