L’événement On se met à l’oeuvre est en cours. N’attendez pas!  Magasinez maintenant
Choisissez vos options

Aperçu

Modèle # DCS16250-1 Internet # 1000664810

Il s'agit d'un clou de finition de 2-1/2 pouces de calibre 16, livré à raison de 1000 clous par boîte. Il a une finition brillante et une pointe biseautée. 50 attaches sont fournies par bâton pour minimiser le rechargement. Ce clou est conçu pour s'adapter à n'importe quelle cloueuse de finition de calibre 16 avec une capacité de 2-1/2 pouces. Fabriquant une gamme complète d'outils électriques, d'équipements et d'accessoires, Dewalt propose un produit pour chaque situation. De la construction de maisons neuves à l'entretien des bâtiments. De la ferme au travail du bois haut de gamme. Tous, des professionnels chevronnés aux amateurs occasionnels, utilisent les outils Dewalt chaque fois qu'ils veulent que le travail soit bien fait.

  1. Compatible avec la plupart des cloueurs de finition droits de calibre 16
  1. Construction en acier
  1. Finition brillante
  1. 2-1/2 pouces de long
  1. La boîte contient 1 000 clous
  1. Outils IPG : D51256K, D51257K, DC616K, FN250B, FN250C

Spécifications

Dimensions

Hauteur assemblé (en pouces)
5.06
Hauteur de l’emballage (en pouces)
1.5
Largeur assemblée (en pouces)
6.25
Largeur de l’emballage (en pouces)
2.88
Poids assemblé (en livres)
16.50
Poids de l’emballage (en livres)
2.17
Profondeur assemblé (en pouces)
9.31
Profondeur de l’emballage (en pouces)
3.88

Détails

Assemblé
Certifié
Couleur et fini
Zingué
Diamètre de la tête (en po)
2.13
Dintérieur ou Dextérieur
Interieur
Fini/matériau du produit
Galvanisé
Longueur (en pouces)
2.5
Longueur du produit
2-1/2 po.
Matériau
Acier
Pays d'origine
TW-Taiwan
Poids du produit
2.16 lb
Quantité par paquet
1000
Taille
8D
Type
Clou de finition
Type de tige
Lisse
Type de tête
Plat

Garanties et certifications

Numéro de téléphone du Service à la clientèle : 1 800 567-7188
Clou de finition à coller de calibre 16 2-1/2 pouces galvanisé (1000 par boîte)DEWALT Clou de finition à coller de calibre 16 2-1/2 pouces galvanisé (1000 par boîte)Il s'agit d'un clou de finition de 2-1/2 pouces de calibre 16, livré à raison de 1000 clous par boîte. Il a une finition brillante et une pointe biseautée. 50 attaches sont fournies par bâton pour minimiser le rechargement. Ce clou est conçu pour s'adapter à n'importe quelle cloueuse de finition de calibre 16 avec une capacité de 2-1/2 pouces. Fabriquant une gamme complète d'outils électriques, d'équipements et d'accessoires, Dewalt propose un produit pour chaque situation. De la construction de maisons neuves à l'entretien des bâtiments. De la ferme au travail du bois haut de gamme. Tous, des professionnels chevronnés aux amateurs occasionnels, utilisent les outils Dewalt chaque fois qu'ils veulent que le travail soit bien fait.
DEWALT
1000664810
CAD27.562024-05-22
Home Depot Canada
Clou de finition à coller de calibre 16 2-1/2 pouces galvanisé (1000 par boîte) est évalué 4.7 de 5 de 327.
  • y_2024, m_5, d_22, h_5
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasreviews, tv_78, tr_249
  • loc_fr_CA, sid_1000664810, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getAggregateRating, 76ms
  • REVIEWS, PRODUCT
Rated 5 de 5 de par I’m trying to figure out why I’m asked to write... I’m trying to figure out why I’m asked to write a review on a box of nails but here goes. I found these nails excelled at attaching pieces of wood together however I would not recommend them for using on half inch plate steal, mainly because they’re nails. They have a classic design as nails often do. Pointy end and blunt end very similar to nails from the Iron Age. They did feed extremely well through my Ryobi Air Strike (unlike nails from the Iron Age). I hope this review helps you with the painstaking task of deliberating over which box of nails to choose but let’s face it if your reading reviews on nails you probably are still trying to decide between the white or the wheat toast and haven’t even made it to the store yet.
Date de publication: 2021-05-18
Rated 5 de 5 de par worked great I wish the big box stores still provided the smaller size containers of brads and staples so I could keep more sizes on hand without making as big of a $ commitment
Date de publication: 2014-02-04
Rated 4 de 5 de par A good value This is as advertised oilless light duty air compressor, it drives 2 1/2 inch steel quite well. I would not use it for a roofing job but for quick work like moldings as it is well suited for that type of work. I used it for trim and small repair work, worked as well as any other Pancake air compressor in this class. The bonus in my purchase was the two mailers included. Everything worked right out of the box. One thing that you need to do to start out is read instructions first, like close the drain vent on the bottom of the machine.
Date de publication: 2016-01-26
Rated 5 de 5 de par These nails fit well into the nailer. They exited the nailer cleanly and held trim in place where... These nails fit well into the nailer. They exited the nailer cleanly and held trim in place where directed. I have attached a photo of the nails in action. The nails are not actually visible in the photo so I have highlighted some locations of the nails. Please note that many more nails were used on this job but the picture became cluttered with too many arrows and I deleted many of them. Yes, these nails met my expectations over the past two weeks.
Date de publication: 2017-03-14
Rated 4 de 5 de par Nails loaded and moved through the nail gun without any... Nails loaded and moved through the nail gun without any jams, and are holding securely. As these were the 2.5” nails, I had a little issue with the nail not being seated below the surface of the trim board. It was difficult to position a nail set securely on the top of the nail to seat the nail.
Date de publication: 2018-09-05
Rated 4 de 5 de par Interior use I could only find these for interior use. All of the other sizes have a galvanized or coated for exterior use . I could not even find a stainless for exterior use. Other than lack of finding exterior nails in this huge they work well for interior use.
Date de publication: 2017-04-11
Rated 4 de 5 de par These worked well for the nail gun we have, but... These worked well for the nail gun we have, but due to the size and shape of the heads, they did leave rather large holes when using them to attach MDF Wainscotting. We tried a few different pressure settings, and this continued to be a problem.
Date de publication: 2018-01-17
Rated 4 de 5 de par Consistent, strips strips stay together in normal handling, come off... Consistent, strips strips stay together in normal handling, come off 1 at a time as they should. Occasionally bend or curl in tough wood or knots but that is just the nature of a thin nail in tough wood, not a defect in the product.
Date de publication: 2017-09-12
  • y_2024, m_5, d_22, h_5
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasreviews, tv_78, tr_249
  • loc_fr_CA, sid_1000664810, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 21ms
  • REVIEWS, PRODUCT

Can I use any finish Nail for my Porter Cable Nailer or do I have to use your nails?

Can I use any finish Nail for my Porter Cable Nailer or do I have to use your nails?
Posée par: Skip
I’m confident that as long as you have the right size and type of nail any brand will work.
Répondue par: Wesburrows
Date de publication: 2023-05-05

Are these nails stainless? Are they rated for exterior use?

Are these nails stainless? Are they rated for exterior use?
Posée par: RoyGBiv
They are rated for exterrior.
Répondue par: HomeDepotCustomer
Date de publication: 2023-05-06

Can I use these brads in my porter cable 18 gauge nail gun. If not, does porter- cable make 18 g...

Can I use these brads in my porter cable 18 gauge nail gun. If not, does porter- cable make 18 gauge 2-1/2 in. finish nails.
Posée par: Sil
they make 2 1/2" finish nails for 18 gauge. These nails are for a 16 gauge gun. You can only use 16 gauge nails for a 16 gauge gun.
Répondue par: bg
Date de publication: 2023-05-05

can smaller 16 gauge finish nails be used in this tool? RIDGID R250SFA...EXAMPLE: 1 INCH LONG

Posée par: RANDY
The manual for the R250SFA Says it will handle nails as short as 3/4”
Répondue par: DIYonSteroids
Date de publication: 2023-05-05

Will these nails fit the craftsman nailer

Posée par: rich
Without a model number it is not possible to answer whether these nails will fit.
Répondue par: Communityanswer
Date de publication: 2023-05-03

are these good for exterior or will they rust ?

Posée par: Rendell
Hi Rendell, This model PFN16200-1 is for interior use only
Répondue par: DewaltProductExpert
Date de publication: 2020-12-02
  • y_2024, m_5, d_21, h_6CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_6
  • loc_fr_CA, sid_1000664810, prod, sort_[SortEntry(order=NUM_ANSWERS, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getContent, 49ms
  • QUESTIONS, PRODUCT