L’événement On se met à l’oeuvre est en cours. N’attendez pas!  Magasinez maintenant

Aperçu

Modèle # P360 Internet # 1000721751

Le système ONE+MC de 18 V de Ryobi présente le nouvel ajout indispensable à la gamme AirStrike. Lagrafeuse à couronne étroite sans fil de calibre 18 est dotée de la technologie AirStrike qui élimine le besoin de compresseurs bruyants, de tuyaux encombrants et de cartouches de gaz coûteuses. Cela se traduit par une préparation plus rapide et une utilisation plus facile sur le chantier ou à la maison. Lagrafeuse AirStrike ONE+MC de calibre 18 de Ryobi est utilisée avec des agrafes à couronne étroite de 0,64 cm (¼ po).

  1. Pour agrafes à couronne étroite de 0,95 cm ( po) à 3,8 cm (1 ½ po)
  1. Mode séquentiel unique pour un positionnement précis Mode par contact pour rapidité dexécution
  1. Dispositif de verrouillage évitant le déclenchement à vide, qui permet de prolonger la durée de vie du moteur
  1. Le dispositif de réglage de la profondeur sans accessoire contribue à protéger la surface de travail et à positionner les agrafes avec précision
  1. Technologie de lampe intégrée à la poignée activant le voyant à DEL lorsque lutilisateur saisit la poignée
  1. Nouvelle poignée surmoulée améliorée pour assurer une prise optimale et le confort de lutilisateur
  1. Inclut : (1) Agrafeuse AirStrike P360 de calibre 18, agrafes à couronne étroite, agrafes pour échantillons, (1) clip ceinture et manuel d'utilisation (batterie et chargeur vendus séparément)

Spécifications

Dimensions

Hauteur assemblé (en pouces)
10
Hauteur de l’emballage (en pouces)
10
Largeur assemblée (en pouces)
3.54
Largeur de l’emballage (en pouces)
3.54
Poids assemblé (en livres)
6.52
Poids de l’emballage (en livres)
6.52
Profondeur assemblé (en pouces)
11.73
Profondeur de l’emballage (en pouces)
11.73

Détails

Article individuel, Ensemble
Article individuel
Calibre (cal.)
18
Certifié
Nombre de pièces dans l'ensemble
1
Pays d'origine
CN-China
Source dalimentation
Sans fil
Système de batteries
Ryobi ONE +
Taille maximale de lattache (en po)
1-1/2
Taille minimale de lattache (en po)
3/8
Tension de batterie
18 V

Garanties et certifications

Garantie limitée de 3 ans. Pour plus d'informations, contactez le 1-800-525-2579
18V ONE+ AirStrike Agrafeuse à couronne étroite sans fil de calibre 18 (outil seulement)RYOBI 18V ONE+ AirStrike Agrafeuse à couronne étroite sans fil de calibre 18 (outil seulement)Le système ONE+MC de 18 V de Ryobi présente le nouvel ajout indispensable à la gamme AirStrike. Lagrafeuse à couronne étroite sans fil de calibre 18 est dotée de la technologie AirStrike qui élimine le besoin de compresseurs bruyants, de tuyaux encombrants et de cartouches de gaz coûteuses. Cela se traduit par une préparation plus rapide et une utilisation plus facile sur le chantier ou à la maison. Lagrafeuse AirStrike ONE+MC de calibre 18 de Ryobi est utilisée avec des agrafes à couronne étroite de 0,64 cm (¼ po).
RYOBI
1000721751
18V ONE+ AirStrike Agrafeuse à couronne étroite sans fil de calibre 18 (outil seulement) est évalué 4.6 de 5 de 909.
  • y_2024, m_5, d_24, h_6
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasreviews, tv_53, tr_856
  • loc_fr_CA, sid_1000721751, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getAggregateRating, 74ms
  • REVIEWS, PRODUCT
Rated 5 de 5 de par Awesome I got this because I needed to do some carpeting and I am a member of Ryobi's One+ family. I will say that this is amazing. I love that I can have a pneumatic type staple gun without having to get an air compressor and hose. Frankly the only thing that I wish could have been different is that it could have been available earlier. After getting it I recalled several times in the past that this would have been useful. It was able to easily handle anything I was able to throw at it. If you are in the market for a heavy duty staple gun and are a member of the Ryobi One+ family this should be an auto-buy.
Date de publication: 2014-01-09
Rated 5 de 5 de par This was my very first time using a stapler of... This was my very first time using a stapler of this type. I did have some problems with driving the 1 1/2 inch staples, but it could have been the generic brand of staples I was using. The 1 inch staples that came with the tool and the brand name ( Dewalt) 1 1/4 inch staples I purchased worked a lot better. I did have to experiment to get the right setting for the depth and the compression, but I was able to get it figured out. I have some other uses for the tool so I will get a better feel for it as I go. The only drawback I found is that you can only get the ryobi staples directly from ryobi. I feel tat if Home Depot is an exclusive vendor,it would make sense for them to have all the accessories in the store.
Date de publication: 2017-12-06
Rated 5 de 5 de par Awesome Stapler, Love It! This is a tool that I thought I wouldn't use very much, so I purchased the other AirStrike nailers first, both the Finish Nailer and the Brad Nailer. I use them all of the time with baseboards and trim. But this stapler is used primarily on my carpet jobs, stapling the tack strip down, and upholstering carpet on stairs. I do tend to try to use the longest staple that it shoots, but would probably be happier with it's performance if I use various lengths for what each job calls for. Use the 4.0AH batteries with these AirStrike nailers/staplers. The smaller compact batteries work well for these, but I am very partial to the Large 4.0Ah ones. Buy this stapler! You won't be disappointed!
Date de publication: 2014-12-02
Rated 5 de 5 de par Awesome tool Saves a ton of time messing with air hoses, you will find a million uses for this one, I have had a 18V Ryobi set of tools for 10 years, and they all work good still, I really like how fast it can reshoot, and am amazed at how well it drives an 1 1/2" 18 gauge brad, I used it to make redwood box planters, and it worked flawlessly. would be excellent for crown molding, picture frames, door finish, cabinet work, all kinds of uses. You will spend a little more than you would for a conventional air type unit, but, the hassle free go anywhere ability, is worth the extra.
Date de publication: 2014-03-21
Rated 5 de 5 de par I'm in love!Should have gone this route years ago!I bought it to attach ceiling tiles to make it ... I'm in love!Should have gone this route years ago!I bought it to attach ceiling tiles to make it easier and faster to work overhead.Broke it in yesterday attaching moulding around a door.Done in ten seconds:)Practiced on scrap pieces to get the hang of it and adjust the depth.Being a senior lady I was concerned it would be too heavy but it's not at all.SO much easier then swinging a hammer,no dropped or bent nails,no going back with a nail set,just spackle and DONE!Some of the pages were missing from the manuel so it took a few minutes to figure out how to increase the power of the strike by turning the round dial in the back.No jambs at all and I'm very pleased with the power and performance.
Date de publication: 2018-02-17
Rated 5 de 5 de par I was doing some remodeling and needed to go beyond... I was doing some remodeling and needed to go beyond hammer and nails, so I gave this Ryobi a shot, since I have been very happy with my Ryobi drill/driver. OMG, this is a great unit! My neighbor offered to loan me his air nailer and compressor but why put up with the noise, the hose, the power drain. This Ryobi fires 18 gauge staples flawlessly and with the air pressure adjustment and depth adjustment it puts the staples exactly where I want them. Why didn't I buy this unit 10 years ago? Well, they didn't make it that long ago, but I can think back to hundreds of jobs where I could have used this Ryobi again and again and gotten excellent results!
Date de publication: 2018-06-19
Rated 5 de 5 de par I Waited till I owned it about a year to write this review. I am a maintenance person for a large apartment complex & I bought this for work use and home shop use (home wood shop) & I have to say after having it a while I am very impressed at the quality and how the only times I think it is broke or it did not work is when it ran out of staples. in a few instances it does not drive the staple completly into some of the oak or a knotted piece of wood I run into but in most cases even in oak or hard wood it drives them just fine. This is one of my favorite tools and I plan to buy the airstrike angled finish nailer next. I don't normally drive more than 20 to 50 staples in a normal day but have never ran out of battery so far. I've had no problems with this tool. The depth setting is very nice for the softer woods also.
Date de publication: 2015-11-25
Rated 5 de 5 de par Saves dragging out the compressor I really was skeptical about using a battery driven stapler to finish off a wood project. For years only an air driven stapler could drive the staples into a hard wood and keep them attached. Well times have really changed. Not only will this unit drive in the narrow crown staples, but even the smallest of the L ION Batteries holds up to easily driving two sticks of staples with reliability. The tool is easy to adjust from driving pine to the densest of the dark walnuts to either just below the surface or deeper, when filler needs to be applied. Looks like that 220v compressor is going to be used less and less often!
Date de publication: 2015-10-08
  • y_2024, m_5, d_24, h_6
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasreviews, tv_53, tr_856
  • loc_fr_CA, sid_1000721751, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 48ms
  • REVIEWS, PRODUCT

Will the staples work for refinishing chair fabric?

My wife is refinishing 2 chairs with new fabric. I want to get her a staple gun that doesn't require a compressor, not too heavy/bulky, but a stable piece of equipment. Will this work? Thank you for your answers.
Posée par: jgstaplerguy
This should work really well as long as the chair bottom is thick enough. I like the fact that you can dial back the pressure. This is one of my favorite tools to use.
Répondue par: CHRISTINE
Date de publication: 2023-05-03

Can you use this tool for fence pickets ?

Example: I have looked at the manual and can't figure out what I did wrong.
Posée par: Jalvarez
Yes you can. Be sure you are using the correct size crown staple and test on a picket to set your pressure correctly.
Répondue par: Rick
Date de publication: 2023-05-03

Can you use nailes too or only staples

Posée par: Patrick
Hi Patrick. This model will only use staples. thanks for asking. Greg
Répondue par: RYOBI Tools Team
Date de publication: 2023-05-06

Available

When is this item going to be available to purchase?
Posée par: ROBERT
Thank you for your recent inquiry with The Home Depot. Unfortunately, we do not have an estimated date for this item to return to stock at this time. For any other questions, please call us at HomeDepot.com Customer Service 800-430-3376.
Répondue par: THDCustomerSupport
Date de publication: 2023-05-03

Can this use Arrow T50 staples?

Can this use Arrow T50 staples?
Posée par: Laurie
No, the T50 Staples are wide. This unit is designed to fire Narrow Staples. 18 Gauge Narrow Crown Staples.
Répondue par: TONY V
Date de publication: 2023-05-05

will it attach 1/4 inch birch underlay to 3/4 inch hardwood subfloor

Posée par: bod
Absolutely. Great application actually.
Répondue par: Paul
Date de publication: 2023-05-03

does this just drive staples or does it also drive 18 gauge brads?

does this just drive staples or does it also drive 18 gauge brads?
Posée par: HomeDepotCustomer
This one does both.
Répondue par: Frosty
Date de publication: 2023-05-04

Can it be used for wall molding on grid ceilings

Posée par: Bill
I have not used it for molding. But I see no reason that it wouldn't work for it. Just make sure your staples are the proper length and your air pressure is set correctly. You might want to try it on some scrap pieces to make sure you have it set. It works very well and easily adjusts for different applications.
Répondue par: PapaBear
Date de publication: 2023-05-06
  • y_2024, m_5, d_24, h_6CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.42
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_144
  • loc_fr_CA, sid_1000721751, prod, sort_[SortEntry(order=NUM_ANSWERS, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getContent, 73ms
  • QUESTIONS, PRODUCT