En raison de l'augmentation importante du volume des commandes, certaines commandes peuvent être retardées pour la cueillette. Veuillez attendre le courriel indiquant que votre commande est prête à être ramassée avant de vous rendre au magasin.  En savoir plus

SharkBite Raccord de réduction, 3/4 po x 1/2 po (paquet de 5)

Modèle nº UP058CA5|Nº UGS 1001013226

Aperçu

Modèle # UP058CA5 Internet # 1001013226

Le raccord en PEX cannelé de SharkBite (paquet de 5) est une solution simple et économique pour raccorder les tuyaux en PEX. Fabriqués à partir de polymères de formule améliorée, ces raccords sont une solution idéale pour les endroits où des raccords en laiton résistants à la dézincification seraient sujets à la corrosion. Les raccords en plastique PEX cannelés de SharkBite conviennent aux applications de distribution deau potable et de chauffage hydronique. Ces raccords en PEX peuvent être utilisés avec le système de bagues de serrage en acier inoxydable ou le système de bagues de sertissage en cuivre (vendus séparément). La gamme de produits en PEX cannelés de SharkBite comprend un vaste éventail de raccords, collecteurs, robinets, bagues de serrage, bagues de sertissage et outils de différentes dimensions pour vous aider à mener à bien votre prochain projet de plomberie.

  1. Construction en polysulfone
  1. Certifié sans plomb et résistant à la corrosion
  1. Répond aux normes de l'UPC, l'IPC et du cUPC
  1. Compatible avec les tuyaux en PEX
  1. Répond aux normes NSF 61, ASTM F 877 et CSA 137.5
  1. Homologué à 200 °F et 200 psi

Spécifications

Dimensions

Hauteur assemblé (en pouces)
6.50
Hauteur de l’emballage (en pouces)
0.748
Largeur assemblée (en pouces)
4.50
Largeur de l’emballage (en pouces)
4.874
Poids assemblé (en livres)
0.69
Poids de l’emballage (en livres)
0.057
Profondeur assemblé (en pouces)
10.75
Profondeur de l’emballage (en pouces)
6

Détails

Entretien des installations
Non
Matériau
Polymère
Pays d'origine
AU-Australia
Raccord
Raccord cannelé
Taille du raccord
3/4 x 1/2 po.
Type de raccord
Manchon
Utilisation
Eau potable

Garanties et certifications

Pour en savoir plus sur la garantie offerte pour ce produit, veuillez contacter notre centre de service à la clientèle en ligne au 1-888-820-0120.
Raccord de réduction, 3/4 po x 1/2 po (paquet de 5)SharkBite Raccord de réduction, 3/4 po x 1/2 po (paquet de 5)Le raccord en PEX cannelé de SharkBite (paquet de 5) est une solution simple et économique pour raccorder les tuyaux en PEX. Fabriqués à partir de polymères de formule améliorée, ces raccords sont une solution idéale pour les endroits où des raccords en laiton résistants à la dézincification seraient sujets à la corrosion. Les raccords en plastique PEX cannelés de SharkBite conviennent aux applications de distribution deau potable et de chauffage hydronique. Ces raccords en PEX peuvent être utilisés avec le système de bagues de serrage en acier inoxydable ou le système de bagues de sertissage en cuivre (vendus séparément). La gamme de produits en PEX cannelés de SharkBite comprend un vaste éventail de raccords, collecteurs, robinets, bagues de serrage, bagues de sertissage et outils de différentes dimensions pour vous aider à mener à bien votre prochain projet de plomberie.
SharkBite
1001013226
CAD8.38
Home Depot Canada
Raccord de réduction, 3/4 po x 1/2 po (paquet de 5) est évalué 4.9 de 5 de 13.
  • y_2021, m_6, d_15, h_18
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.17
  • cp_1, bvpage1
  • co_hasreviews, tv_1, tr_12
  • loc_fr_CA, sid_1001013226, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getAggregateRating, 45ms
  • REVIEWS, PRODUCT
Rated 5 de 5 de par Rating provided by a verified purchaser... Rating provided by a verified purchaser
Date de publication: 2021-01-29
Rated 5 de 5 de par Was putting up a sprinkler for my lawn and needed couple of these couplings to join and split the... [This review was collected as part of a promotion.] Was putting up a sprinkler for my lawn and needed couple of these couplings to join and split the lines. These look good, fit well and i like the flexibility to have these to be able to cover all the vegetable garden and rest. I would certainly recommend these. Make sure you are looking for this exact sizes, coz my neighbor bought the same and they didn't fit his.
Date de publication: 2019-01-10
Rated 5 de 5 de par A quality alternative to copper or galvanized pipe for water plumbing systems. A reducer is ofte... [This review was collected as part of a promotion.] A quality alternative to copper or galvanized pipe for water plumbing systems. A reducer is often an additional cost savings technique to scale down size of valves or other fittings if full flow is not needed. Scaling up, or using this fitting as an “increaser” is often required to keep proper flow. Keep in mind that 3/4 inch PEX pipe is about the same internal diameter as 1/2 inch galvanized. Barbed fittings are smaller diameter yet, since they fit inside the pipe. It is a good idea to properly size your system if you are installing any length of pipe or doing a large project. Good price for a quality fitting, and readily available.
Date de publication: 2019-01-10
Rated 5 de 5 de par Here is another new arrival for my waterline replacement project, 3/4 X 1/2 In. Plastic PEX Barb ... [This review was collected as part of a promotion.] Here is another new arrival for my waterline replacement project, 3/4 X 1/2 In. Plastic PEX Barb Reducer five pack, by SharkBite. I am on a well system and the water pressure is fairly low. So all of the under the house runs are 3/4 in PEX, reduced to 1/2 in. PEX near the risers, and above the floor. Simply cut the PEX tubing squarely, slip on the crimp ring, and crimp with the appropriate crimping tool, Quick, simple, and clean. Another fine product from SharkBite.
Date de publication: 2019-01-09
Rated 5 de 5 de par [This review was collected as part of a promotion.] The 3/4 in. x 1/2 in. Plastic PEX Barb Reducer Coupling is an excellent fitting. The body of the fitting as well as both ends have a great finish, no sharp ends or burrs. Provides a good tight connection. I have specified and used this type of fitting for many years. I am now retired and spend most of my time in my yard and garden.Sometimes it is necessary to bring water to areas where the sprinklers just don't reach, vinyl tubing and barbed, threaded or compression fittings are perfect to reach these goals. Yes, I like and recommend these fittings. Ref: https://www.homedepot.com/p/SharkBite-3-4-in-x-1-2-in-Plastic-PEX-Barb-Reducer-Coupling-5-Pack-UP058A5/206133156
Date de publication: 2019-01-05
Rated 4 de 5 de par I use PEX pipe for every water line these days. I normally run a 3/4" main line and then 1/2" li... [This review was collected as part of a promotion.] I use PEX pipe for every water line these days. I normally run a 3/4" main line and then 1/2" line to each fixture. Many times I need a reducer coupler to change from the 3/4" main line to a smaller 1/2" line. One great thing about using PEX and these fittings is you can turn water on immediately. There is no reason to wait for glue to dry using these fittings.
Date de publication: 2019-01-04
Rated 5 de 5 de par PEX 3/4 inch to 1/2 inch plastic barbed reducing couplings are great to use when installing new P... [This review was collected as part of a promotion.] PEX 3/4 inch to 1/2 inch plastic barbed reducing couplings are great to use when installing new PEX tubing for new installations or retrofitting old work. I prefer the plastic fittings when installing PEX plumbing in my home. I have found that the brass fittings get calcification building up, and begin to plug-up within a year or so after installing them. That doesn't seem to happen with the plastic fittings.
Date de publication: 2018-12-31
Rated 5 de 5 de par [This review was collected as part of a promotion.] These things can be a time saver as well as a quick way to do repairs. I got a couple packs of these in different variations. The sizes I got were for rubber hose repairs and to make longer lengths as well as attach a barbed end adapter for some machinery.. So far so good even with some hot water running thru some they perform as I expected. Just used the last of them for a sump pump hose I actually use at home in a sink that tends to overflow during heavy rain storms. Saved me from having to wet vac the floor this last storm.
Date de publication: 2018-12-17
  • y_2021, m_6, d_15, h_18
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.17
  • cp_1, bvpage1
  • co_hasreviews, tv_1, tr_12
  • loc_fr_CA, sid_1001013226, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_homedepot-canada
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 19ms
  • REVIEWS, PRODUCT
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getContent, 32ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: The resource to the URL or file is currently unavailable.;