Anchor Bolts

Paulin 1/2-inch x 8-inch Pro Pack Hot Dipped Galvanized Carriage Bolts (5 Sets)

Save time with Paulin's new Carriage Bolt Pro Pack. Each bag contains: 1/2x8 Carriage Bolt Grade 2 (5), 1/2 Plain Steel Washer (5), 1/2 Plain Lock Washer (5), 1/2-13 Finished Hex Nut Grade 2 (5). Hot-dipped galvanized finish.

Paulin 1/2 x 8-inch Carriage Bolt - Zinc Plated - Grade 2 - UNC

Carriage Bolts are used in wood or metal to wood applications with a domed top and a square under the head. This pulls into the wood as the nut is tightened. When using carriage bolts always use a flat washer between the wood and hex nut to eliminate pull-through of the nut in the wood. Drill pilot hole slightly larger than body diameter of bolt. Insert the carriage bolt so the headed end is on finished side of project for appearance or safety. Length is measured from under head to end of bolt. Steel is zinc plated for moderate protection against rust. Use hot dipped galvanized finish or stainless steel where corrorsion and rust is of concern or for exterior projects.

Paulin 1/2 x 6-inch Hex Head Lag Bolt - Hot Dipped Galvanized

Lag Bolts are also called Lag Screws and are recommended for all types of wood or metal to wood construction where standard wood or deck screws are too short or light and where nails or spikes lack sufficient strength. They can be installed in wood with pre-drilled pilot holes or in masonry with Lag Shields. In wood to wood applications the non-threaded shank allows the second piece to be drawn tightly to the first piece of wood. Flat or fender washers are suggested to provide a larger bearing surface and to prevent the head of the lag bolt from imbedding in the first piece of wood. Hot dipped galvanized finish provides one of the highest degree of corrosion resistance when compared to a steel zinc finish. Ideal for outdoor projects such as decks, fences, wood structures and with treated lumber installations.

Simpson Strong-Tie RFB 1/2 inch x 5 inch Hot-Dip Galvanized Retrofit Bolt

RFBs are clean, oil-free, pre-cut threaded rod, supplied with nut and washer. Offers a complete engineered anchoring system when used with Simpson Strong-Tie adhesive. Inspection is easy; the head is stamped with rod length and "No Equal" symbol for identification after installation.