Howell Floating Dock Outside Corner End

Floating Dock Hardware component manufactured from 5 Gauge (1/4") hot dip galvanized steel. Slot size is 9/16" x 1-5/8". Use Outside Corner End to strengthen outside corners. Outside Corner use with backer plates or inside corner at outside end of docks, fingers or swim platform.

Multinautic Dock Hinge Pin 3/4 inch

The replacement Multinautic(TM) dock hinge axle is used to join male and female hinge together. It fits 13303, 13309, 13310 and 10007 Multinautic(TM) connector hinges.

Patriot Docks HD Wheel Stop Collar (pair)

The HD wheel stop clamps attach to a pipe axle to hold the wheels. The HD wheel stop clamps fit 1-1/2" schedule 40 pipe. The Dock Wheel Clamp keeps your dock wheels securely in place along the pipe axle, preventing unwanted shifting during installation or removal. Unlike standard cotter pins, this clamp uses a stainless steel set bolt that offers a stronger, more reliable grip for smooth and controlled rolling. Each set includes oversized wheel washers to protect the wheel hub from wear and tear caused by direct contact with the clamp—extending the life of your dock wheels. Need wheels to go with your clamp? Check out our available Dock Wheels.

Dock Edge Rolling Dock Wheel, 24in

Wheels are available in 18 or 24 diameters and up to 1500 lb. capacity per wheel. These tough, rigid wheels offer stress, crack and impact resistance. They roll easily over virtually any terrain and will not rust on the axle. Use for roll-in docks or boat lifts. All wheels accept a 1-7/8 O.D. Axle. See chart below for wheel capacity.