Model # 09101|Store SKU # 1000858115
"NaturaSet's Barrier Seam tape is a 20mils thick flashing tape with anti-skid top film surface, made of acrylic adhesive ultra-bonding strength to seal around roof, windows, doors, and other joinery seams. It is suitable for all kinds of wet, hot and cold environments. The rough surface of the backing allows adhesion of spray or liquid sealants and weather-resistant coatings. The adhesive layer is covered with a disposable poly-coated Kraft paper release liner."
Enjoy the look of expensive, heavy roofing tiles without the added cost and difficulty of installation using the Ondura 79-inch Organic Fiber Roof Panel. These panels can be installed directly over previous materials, creating additional savings by eliminating disposal of non-biodegradable shingles. For lifelong use, the panels are impregnated with asphalt to ensure maximum strength.
Enjoy the look of expensive, heavy roofing tiles without the added cost and difficulty of installation using the Ondura 79-inch Organic Fiber Roof Panel. These panels can be installed directly over previous materials, creating additional savings by eliminating disposal of non-biodegradable shingles. For lifelong use, the panels are impregnated with asphalt to ensure maximum strength.
This heavyweight fibreglass, 3 tab shingle, produced with wind resistant Weather Tite technology, is strong and durable for extraordinary protection in the toughest weather conditions. The innovative shadow band creates an eye-catching, chiseled style. BP shingles are now made with an elastomeric modified asphalt that makes them more flexible, more resistant, and delivers the highest level of durability against nature’s worst weather.
Prime the substrate with ELASTOCOL STICK or EXTERIOR PRIMER. Position the membrane parallel to the lower edge of the roof. Fold the sheet, to half of its width, or 50 cm (20 in) over the whole length already positioned. It is recommended to kneel on the unfolded portion of the membrane to keep it in place during this operation. Remove the protective film from the folded section while placing the membrane on the support. The pressure-sensitive portion will then adhere to the support. Then take the other side of the membrane and repeat the previous two steps. Immediately apply pressure on the membrane using a heavy metal roller or hard rubber roller to ensure adhesion between the support and the membrane and avoid forming bulges, folds or gaps. Use non granulated side portion of the membrane to ensure a good overlap of about 10 cm (4 in) from each edge. The overlap must be positioned on the upper side of the slope.
