Model # HE221968|Store SKU # 1001941929
Protect your home from water damage with Peak aluminum gutter, soffit and fascia products. Featuring precision design, our products can help prevent water and moisture damage to the roof, windows, walls and foundation. Made from heavy-gauge aluminum, our products are attractive, reliable and maintenance-free. They won't rust or leak, which is ideal for keeping the exterior of your home looking pristine for many years. Our products are strong and attractive, but what makes them so unique? Every component is finished with exterior polyester paint on the outside and inside to give you a product that is durable and looks great from any angle. Plus, our gutter hanger is engineered to enable quick, safe, one-handed installation! For extra protection, add the Peak Aluminum Gutter Guard to your system to keep leaves and anything as thin as pine needles out! Use the Aluminum Fascia Cover to seal off soffit panels and add visual interest, giving a finished look to your home exterior.
"NaturaSet's Barrier Seam tape is a 20mils thick flashing tape with anti-skid top film surface, made of acrylic adhesive ultra-bonding strength to seal around roof, windows, doors, and other joinery seams. It is suitable for all kinds of wet, hot and cold environments. The rough surface of the backing allows adhesion of spray or liquid sealants and weather-resistant coatings. The adhesive layer is covered with a disposable poly-coated Kraft paper release liner."
Prime the substrate with ELASTOCOL STICK or EXTERIOR PRIMER. Position the membrane parallel to the lower edge of the roof. Fold the sheet, to half of its width, or 50 cm (20 in) over the whole length already positioned. It is recommended to kneel on the unfolded portion of the membrane to keep it in place during this operation. Remove the protective film from the folded section while placing the membrane on the support. The pressure-sensitive portion will then adhere to the support. Then take the other side of the membrane and repeat the previous two steps. Immediately apply pressure on the membrane using a heavy metal roller or hard rubber roller to ensure adhesion between the support and the membrane and avoid forming bulges, folds or gaps. Use non granulated side portion of the membrane to ensure a good overlap of about 10 cm (4 in) from each edge. The overlap must be positioned on the upper side of the slope.
Molded Pipe Flashing accessory to fit Onduvilla shingles and cannot be used with Ondura corrugated asphalt sheets. The flashing can be cut by the customer to allow customizing the flashing to fit various sizes of vent pipes. This item can be used with a standard universal boot found in most plumbing departments.
Blueskin ZeroFlash is designed for contractors who need a product that’s as tough as they are – even in the cold winter months. With installation temperatures as low as -18°C (0°F), project timelines stay on track despite extreme temperatures. Featuring a proprietary butyl hybrid compound applied to an engineered polypropylene film, Blueskin ZeroFlash aggressively adheres to multiple substrates across a wide range of installation temperatures for maximum performance.
